2021 Jeep Gladiator

The contact owned a 2021 Jeep Gladiator. The contact stated that while the vehicle was stopped at a corner, another vehicle was speeding and crashed into the front driver's side quarter panel. The impact pushed the vehicle forward, causing the front driver's wheel to swipe a telephone pole before landing on a residential lawn. The other vehicle then crashed into a telephone pole. The front driver's side air bag deployed, but there was a hole in the side air bag and the driver's air bag failed to fully deploy. Additionally, a burning odor was detected after the air bags deployed. The police and fire departments arrived on the scene, and a police report was filed. The contact was transported to the hospital by ambulance. The contact had surgery on her left arm from wrist to elbow, which required four titanium plates. The vehicle was towed to the tow yard and deemed totaled by the insurance company. The manufacturer was made aware of the failure. The failure mileage was approximately 17,250.

On February 25, 2023, while slowing down as I approached an intersection controlled by a red signal light and applied my brakes which was slowing me down. My foot never moved off the brake pedal as I slowed down. Suddenly, the Jeep Gladiator "accelerated/surged" forward and stated gaining speed. Although I was applying constant pressure on the brake pedal, the vehicle never slowed down or stopped because after traveling 200-300 feet and striking two signal light poles and a communications box, the vehicle came to a stop. This was the third incidence of Sudden Unintended Acceleration (SUA). Tshe vehicle is available for inspection and under the supervision of Safeco Insurance. In this case, injuries were limited to a passenger broken toe and the driver being bruised. Similar accidents involving striking stationary poles resulted in death but we were spared that outcome. The first instance of SUA occurred on a street near my home and while applying constant pressure on the brake pedal, the vehicle finally skidded to a stop after traveling approximately 200 feet. The second instance of SUA occurred while pulling into a parking lot, and again, after applying constant pressure on the brake pedal, the vehicle came to a stop after traveling approximately 300 feet. After the first and second instances, I took the vehicle into the dealership, but they could not find anything wrong. The police report blamed an electrical/mechanical failure. No warning lights or messages were noted.

1) Frequent spontaneous windshield cracks. 2) violent, out of control steering wheel vibrations at highway speeds nearly causing severe collisions. Reoccurring incidents. I’m ready to file a lawsuit.

Under heavy breaking the rear wheels of my vehicle lifted off of the pavement. This loss of traction and shift in weight resulted in a head on collision with a vehicle in the opposite lane of traffic. After the accident I discover that the suspension for my vehicle was incorrect to the level that FCA released a TSB regarding the issue. The suspension that was equipped with the vehicle was designed for the gasoline motor and the weight associated with that motor. My vehicle has the diesel motor (approximately 600lbs heavier) along with factory equipped steel bumpers adding additional weight. This factory design failure created a vehicle that could not perform as designed and as I found out via an automotive accident, a vehicle that under heavy breaking can lift its rear wheels off of the ground.

The contact owns a 2021 Jeep Gladiator. The contact stated that while driving at 60 MPH, there was an alarming amount of white smoke emanating from the engine compartment and permeating the interior of the vehicle, prompting the contact to pull over to the shoulder of the roadway and evacuate the vehicle. Moments later, the entire front of the vehicle was completely engulfed in flames. Local Emergency Services arrived on the scene and were able to extinguish the fire. During the failure several unknown warning lights were illuminated. The vehicle was towed to the residence and deemed a total loss by the Insurance provider. A fire report was filed and preliminary findings on the potential cause of the fire were provided but the contact was unaware of the cause. A Police report was filed, and injuries were reported. The contact's father suffered minor burns to both hands but had not sought medical attention. The manufacturer was notified of the failure, a case was opened, and the vehicle was retrieved for inspection. The manufacturer provided a determination of the inspection, and the vehicle was returned to the contact without providing the contact with the cause of the failure. The failure mileage was approximately 20,000.

BRAKE PEDEL TO CLOSE TO GAS PEDEL.. WHEN THE DRIVER PUSHES ON BRAKE PEDEL HE CAN PUSH ON THE GAS PEDEL.. THE TRUCK WENT FORWARD VERY FAST./. I BROUGHT THE TRUCK USED

While slowing to a stop and fully depressing only the brake with my right foot my vehicle rapidly accelerated into the back of another truck. It felt like the front brakes engaged, but the rear wheels continued to accelerate as the vehicle transmission worked to downshift. Serious safety issue-I am 100% confident that I was standing on the brake and not the accelerator. The road was dry with no gravel and I was gradually slowing to a stop when this occurred.

I was exiting the freeway with a speed limit of 75 mph. On the off-ramp I lost control of the Gladiator. The front end wobble was so bad that I could not hold onto the steering wheel for fear of breaking my wrist. Instead I had to wrap my arms about the wheel in an attempt to stop the wobble. I was unable to keep the vehicle in my lane, and finally ended up in a large ditch next to the off ramp. What happened appears to be a problem with the Mopar 1.5" lift kit installed by the dealer. The kit was installed 8/17/2021. This incident occurred in Jan 2022, about 4,000 miles later. I had the kit installed and then inspected about a month later specifically to check for any loose bolts, and to double check the torque for the bolts. The CV bar in the front lost a the bolt on the passenger side, dropping the cross bar and resulting in total loss of control of the passenger side front tire. I felt very lucky not to have been injured, and not to roll the jeep. It took about 150 feet to stop the vehicle in the ditch. I am attaching a photo of the bar held in place after the accident using bungie cords. This was done just to get the bar off the road and allow for moving the vehicle. The mechanic was able to secure the cross bar with a new bolt. The original bolt and nut were not found. We speculate that either the bolt was not torqued correctly or might have been missing a lock washer. At any rate, potentially this could have resulting in much worse. If this happened just a few seconds earlier on the freeway, the damage and injuries could have been much worse. Now the vehicle is driving like new, after new bolt and alignment. However, I will be checking those bolts more frequently, particularly if I notice any extra play in the steering. Before this happened, the play in the steering had increased. I thought I just needed an alignment, but it was much worse than that. Really I would think this cross bar needs redesign to ensure it can't break loose.

My name is [XXX] , and I am writing to formally submit a complaint regarding the loss of my vehicle due to engine fire. The vehicle was a 2021 Jeep Gladiator Rubicon, VIN [XXX] , with approximately 26,666 miles at the time of loss. I purchased the vehicle on May 13, 2021. The fire occurred on July 10, 2025. I was driving on the freeway, and my vehicle lost power and dashboard warning lights illuminated. When I pulled over, the engine was on fire. The fire department came and doused the flames but my entire engine was destroyed. After the fire, I retained legal counsel and initiated an independent investigation through Fire Cause Analysis in Berkeley, California. Their findings identified the origin of the fire as being linked to the power steering pump electrical connector. I later discovered that NHTSA has an open investigation identified as PE24024 concerning Jeep Gladiator engine fires which notes that the fires reported to NHTSA for this vehicle originated at the power steering pump electrical connector - coinciding with the finding of Fire Cause Analysis. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Vehicle is 2 years old, with only 21,000 miles. Driving on the freeway, above 65mph, the vehicle wobbles violently if you hit a pot hole or a small bump. It jerks the steering wheel very hard from side to side, making it very difficult to stay within your lane. The only way to make the extreme wobble go away is to slow down significantly (<40mph) or sometimes come to a complete stop. A simple internet search and you will find MANY complaints about this with Jeeps, and it is commonly referred to as the "Death Wobble". PLEASE help us consumers put an end to this terrifying issue. I was on my way from Austin to San Antonio (1.5-hour drive) and was almost involved in two accidents because of this. Very few drivers expect for the vehicle they are following behind of to slam on their brakes, which is exactly what I had to do on several occasions to control the wobble. I was almost rear ended on the freeway going 60+ mph on more than one occasion. For the sake of every Jeep owner, AND everyone else on the road, Jeep cannot continue to release vehicles with this well-known defect. My vehicle is currently at the dealership being looked at, but I suspect it will be an issue with the suspension parts, either worn or loose. Either way, not acceptable for a vehicle with this type of mileage. No warning lamps or messages given before the wobble occurs. As mentioned before, you hit one pothole or bump the right way and it starts to wobble very violently.

Bought this vehicle with 27,000 miles on it. While driving on the interstate with heavy traffic. (Doing Highway speeds) All the sudden the power plant shuts down. It happend at 27,500 miles and happened again at 37,000 miles. It has done it to me four times now. Twice with heavy semi trucks bearing down on me and my family. This was a very UNSAFE situation. The Fault on the screen comes up momentarily and states "Capture Throttle Body Fault." and all power is lost to the throttle. SERIOUS SAFTETY ISSUE. as loosing power on the interstate at 75 miles an hour. I believe JEEP the company should fix this issue as I know for a fact I am not the only individual experincing this problem! Please feel free to reach out to me if you need further information. There was not a crash,fire or injury due to the ability to get off the road and into the apron of the interstate. In a higher traffic location this could be catistrophic. PLEASE PLEASE PLEASE talk this issue seriously as I am convinced this has caused others to wreak. Thanks and have a great day

The contact owns a 2021 Jeep Gladiator. The contact stated that the instrument panel was blank at startup. Due to the failure, the speedometer, fuel gauge, mileage, and other features were not visible. Upon investigation, the contact discovered NHTSA Campaign Number: 24V652000 (Electrical System); which was associated with the failure. A dealer was notified of the failure, and the contact was informed that the vehicle was not included in the recall. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 49,000.

Description of the Safety Issue I am submitting this complaint to report a serious seat belt safety incident involving entrapment and inability to self‑release, which required emergency intervention. While parked, my daughter as a passenger in my Jeep Gladiator, became tangled in the seat belt in such a way that she was physically unable to release herself or exit the vehicle. Despite multiple attempts, the seat belt could not be disengaged, and the situation escalated to the point where I had to cut the seat belt to free her. This was not caused by a crash, sudden stop, or misuse. The seat belt’s configuration, retraction behavior, or release mechanism appeared to contribute to the entrapment and prevented normal occupant egress. Why This Is a Safety Concern Seat belts are intended to protect occupants and allow safe release when needed. In this incident, the seat belt instead: -Entrapped a child occupant -Prevented self‑release -Created a situation where cutting the belt was the only way to avoid further harm Had this occurred during an emergency (fire, water submersion, post‑collision scenario), the inability to quickly exit the vehicle could have resulted in serious injury or worse. Outcome of the Incident -No collision occurred. -No vehicle warning lights or alerts were present. -The seat belt was rendered unusable only because it had to be cut as an emergency safety measure. -The incident caused significant distress and created an immediate safety hazard. Request for Review I am requesting that NHTSA: -Review this incident as a potential seat belt design or functional defect -Consider whether similar incidents may be occurring but underreported -Evaluate whether this issue warrants further investigation, service bulletin, or recall activity Seat belts should never place occupants—especially children—into situations where escape is difficult or impossible.

The 3rd brake light in the tailgate malfunctioned This is required to pass New York State safety inspection A Jeep dealer replaced the part No warning on the dashboard of this light failing

Passenger side rear axle leaking gear oil. Issued was repaired by dealership No warning I just saw the oil on the tire and in my driveway

Two of the same faults occurred within the same month of each other. The first: while driving home from work on the highway, while heavily raining, without warning every alarm light possible engaged, windshield wipers went full speed, vehicle would not shift, and my steering locked up (not to be confused with lost power steering). After about a mile I was able to encourage the Jeep off the side of the highway. While waiting for my tow, with the E Brake set and in Park, the Jeep kept trying to crawl forward on its own. I was unable to turn the vehicle off as it would not respond, in addition to an alarm warning saying not to turn off the Jeep. The second occurrence was in the parking garage at work; I pulled through the parking stall, put the Jeep in reverse to back up and the same fault took place. No steering, wipers on full speed, every alarm on the dash was engaged. Thankfully I was not a highway speed. I was able to turn off the Jeep this time after about 5 minutes of attempting to.

While angling into a turn lane, I was forced to go back into lane of traffic first signaling into the turn lane (left) then out (right) turn signal seemed to get stuck on, Steering wheel became locked and would only move a fraction of an inch either left or right. Once I was around the obstruction in the turn lane I angled back into it and was able to come to a stop. Once stopped the turn signal very loudly clicked off and the wheel was once again able to be actually turned. The ESS was disabled the whole time and at no point did the vehicle cease to be on and engine running.

The center high mounted tail light (CHMTL) has failed. It makes it a little harder to see the vehicle is braking. The fuses are fine. It is a very common failure on Jeep Gladiators. Many times people don't know it has failed. There are no warning lamps or indicators to tell you it has failed.

I have had my gorilla glass replaced two years ago for cracking on its on, my front windshield cracked again 2 weeks ago for no reason and it cracked in the same location, causing a huge crack along my vison. This glass is supposed to be unbreakable and yet it broke twice since ownership all by it self. No rock chips or anything. I was just sitting at a traffic light when I heard a ting and the crack just grew before my eyes. Bad glass and Mopar knows its a flaw but will not replace it.

This afternoon I was driving on a 35mph 4 lane road when my power steering suddenly went out. Because it was unusually light traffic and there are no turns or curves, I was able to safely maintain my lane until the power steering resumed just as quickly as it went out. Most women struggle with manually steering a normal sized car- a truck this heavy is nearly impossible. Had I been going any faster or if I were on a curve, I would have absolutely wrecked. There were no alarms, no signals no messages, nothing. Because this Judy happened, I have not yet had it looked at my a mechanic.